Subfloor Prep For Hardwood Installation

If your concrete subfloor was just poured you ll need to allow it to properly cure for a minimum of 60 days before your luxury vinyl flooring installation begins.

Subfloor prep for hardwood installation.

Wood subfloor measure and cut 1 4 inch or thicker plywood with a circular saw to fit the entire floor of the room where you are installing vinyl flooring. Check out these easy to follow tips from lowes. Bring the flooring into the room so the wood planks can acclimate to the room s temperature and humidity for up to 72 hours before installation follow the manufacturer s instructions. Before you install your plywood subfloor first calculate the room s square footage to find out how much flooring you ll need to buy.

Hardwood flooring will not stabilize the osb subfloor so all movement must be remedied prior to hardwood installation. The key to a beautiful long lasting hardwood or laminate floor is a well prepared subfloor. The goal is to have a wooden subfloor. Each step for subfloor prep contributes to easier installation sanding and finishing with the end product being more flat and pleasing to the eye.

Ensure that the subfloor is flat clean dry and that there is no movement in the subflooring system. Without do so chances are pretty good you may begin to hear strange sounds as the new floor is not comfortable with the sub floor. Some homeowners may choose to go so far as to tear out the old flooring themselves and lay an entirely new subfloor or at least install a thin plywood underlayment to smooth over the subfloor. If the installers arrive at a house with an ideal subfloor the new wood flooring will go in smooth tight and flawless.

Concrete is a common subfloor material and in general it s easy to prepare for a luxury vinyl flooring installation project. Acclimating reduces problems associated with moisture such as warping and fit. If you haven t learned by now surfing through the site one key to successful wood floors is floor preparation. Need to prep your wood subfloor.

Ensure that no fasteners are exposed or raised and that there is at least an 1 8 inch gap between osb subfloor panels.